New Wired Ionisation Smoke Alarm with Interconnect

NEW WIRED IONISATION SMOKE ALARM WITH INTERCONNECT

Interconnect up to 12 other alarms (Ionisation alarms Ei 100C ) – when one senses smoke all alarm. Helps ensure warning will be heard throughout the house.
Main Features:
Interconnect up to 12 other alarms
High sensitivity – responds to all standard fires

Dual ionisation chamber – quick response to fast flaming fires
Mains powered
Built in sounder to give a minimum sound output of 85dB(A) at 3m
Bleeps every 40 seconds when battery needs replacing
Easily installed – no wiring
Test Button simulates smoke – use to check performance at least monthly
Installation:
Pull cover open at Tab. Remove cover from base by separating at rear snap-in hinges

Place the base on ceiling or wall exactly where you want to mount the unit. With a pencil, mark the location of the screw holes

Taking care to avoid any electrical wiring in the ceiling or wall, drill a hole through the centres of the marked locations. Push the plastic screw anchors provided into the drilled holes. Screw in firmly

With a pencil, write the date of battery installation on the inside of the cover to remind you when to replace the battery. Lift battery from battery holder, and snap battery connectors to battery. They fit together only one way. Gently push battery into battery holder. To close the cover match up snap-in hinges and gently press together until base and cover snap together

All models are fitted with a warning flag which pops up when the battery is removed. This prevents the cover from closing when there is no battery in the unit. When the battery is being installed or changed, this flag must be held down while gently pushing the battery into the battery holder